Guides

How to manage technician van inventory

Decide what each van carries, set stock targets, restock with Prepare Missing, and keep usage and returns accurate.

6 minute read

Van stock and job parts are different

Van Stock is general inventory a technician carries for any job—common parts used across many repairs. A Job Part is assigned for one specific Job ID. Keep the two separate: stock targets apply only to Van Stock, and job parts follow their job.

Set stock targets for each technician

  1. 1Open Technicians and select the technician.
  2. 2Open the Stock Targets tab.
  3. 3Choose a part, enter the target quantity, and select Add Target.
  4. 4Repeat for each part that should be on that vehicle. Technicians can have different targets.
StatusMeaning
In StockThe technician holds at least the target quantity.
LowUnits are missing and nothing has been prepared to cover them.
PreparingThe shortfall is covered by stock reserved at the warehouse but not yet collected.

Restock with Prepare Missing

  1. 1On the technician’s Stock Targets tab, select Prepare Missing for a part that is Low.
  2. 2Choose a warehouse with available stock. PorterBase shows how many free units each warehouse has.
  3. 3Confirm. The units are reserved as Van Stock with Ready for Pickup status.

Units already reserved for the technician count against the shortfall, so preparing twice does not reserve the same parts twice.

Hand off at the warehouse

  1. 1The technician opens Ready for Pickup on their phone.
  2. 2After collecting the parts, they select Mark Picked Up. The whole reservation moves at once.

Record usage from the field

  • Mark Used records the quantity installed; the rest stays assigned to the technician.
  • Used units no longer count as on hand, so the part shows Low again when the van needs restocking.
  • Undo Used corrects an installation that was recorded by mistake.

Return or recover van stock

When a part should come off the van, use Return to Warehouse so its warehouse, condition, and history are recorded. If a technician becomes inactive, managers can still see what they hold and return it.